Controller PXM PX254 DMX-512 LED 3x6A
Description
The PX254 driver is designed for voltage control of LEDs. It is an improved successor of the PX139 driver. The built-in DMX receiver allows you to control 3 channels (R, G, B) using the DMX-512 protocol. A wide range of supply voltage and high current-carrying capacity of the outputs (6A) enable the control of large numbers of LEDs. In addition to increasing the load capacity of the outputs, the device uses current protection in the form of fuses that can be replaced by the user.
PX254 can be both controlled by DMX signal and operate independently. In this case, the user has at his disposal a fully programmable scene and 18 pre-programmed sequences, for which he can additionally freely change the playback speed and the smoothness of the change of steps. Thanks to the 16-bit resolution, controlling the parameters of individual channels is completely smooth. In addition, the driver is equipped with a 7-byte control mode, allowing the selection of parameters such as program, speed, brightness and fluidity using the DMX-512 signal.
The driver has been closed in a new, lower and more stable housing.
New high-quality screw connectors ensure reliable contact of the connected wires.
Drivers from the serial number 14330006 have an increased load capacity of outputs up to 6A
Technical data
| application | control: RGB |
| IN/OUT channels | DMX 0/512 |
| input voltage | 12V - 24V |
| power consumption | 70mA (12V) / 40mA (24V) |
| length | 60 mm |
| width | 70 mm |
| height | 86 mm |
| weight | 0.15 |